|
Trunk Props for MGB and MG Midget
Replace your old trunk lid prop with this new self-triggering version. You will LOVE needing only one hand to operate your trunk lid instead of three. Ever take anything out of an MG Trunk? With the factory prop, you have to set your parcel on the ground while you use both hands to shut the trunk lid. never again face this annoyance. Just lift slightly and the prop automatically collapses. This prop also reduces the possibility of your trunk lid being ruined by someone trying to force it shut against the rigid factory prop. Looks like the original equipment and installs easily to existing mounting brackets. Fits approx. 1971 to 1980 MGB and 1971 to 1979 MG Midget.
 | MGB 71-80 | NLA | Reg. Retail
$NLA |
| BRACKET ALLOWS THE ABOVE TO BE USED FOR 1962-1970 MGB'S | $5.00 | |
| Midget 71-79, NO LONGER AVAILABLE, YOU CAN USE CP1033 AND CUT DOWN TO FIT. | |
|
|
|
Gas Charged Prop for MGB Boot
This slick lift cylinder is a wonderful convenience, plus a foolproof guard against getting your boot lid bent as so often happens with the factory prop rods. Open your boot lid with ease, then close it with just an elbow. This prop lets you "slam" your lid shut instead of the factory's method of two hands and a bent back. Also, be absolutely certain no one will EVER ruin your boot lid trying to shut it over the factory's rigid locking prop. This is inexpensive insurance!!
Installs in minutes with just a 7/16" wrench. This design uses the same mounting brackets as your current prop and will fit all MGB boot lids with telescoping props approx. 1971-1980. Now
get a Retrofit Kit to make your single Gas Charged Boot Prop the deluxe dual (DUAL KITS ARE ALWAYS RECOMMENDED)
version. Allows your boot lid to raise automatically when opened and
gives more support to your boot lid. Requires some drilling
| MGB 71-80
- SINGLE GAS CHARGED PROP. (DUAL KIT IS HIGHLY RECOMMENDED TO AVOID BENT TRUNK LIDS AND LONGEVITY OF OF THE GAS CYLINDERS) | $29.00 | Reg. Retail
$34.99 |
| RETROFIT GAS CHARGED - CONVERT FROM SINGLE TO DUAL | $39.00 | Reg. Retail
$47.99 |
| BRACKET ALLOWS THE ABOVE TO BE USED FOR 1962-1970 MGB'S | $5.00 | |
|
|
Rear tailgate gas charged lift kit and instructions for MGB GT
You've asked for it now we have it! Order one of these gas charged MGBGT
Rear Lift Gate kits and see how easy it is to raise and lower your rear
gate. Less expensive than the original stay assembly and trouble
free these new gas charged GT props will give you years and years of service.
Convert your old, worn, greasy steel springs to this custom dual prop format!
This kit works great and looks great!
Your trunk lid will gently rise open all by itself after
you lift it part way.
Plus, you will no longer be wearing holes in your upholstered
panels—that always happens--by the factory springs!
Installation is easy, requiring only minor drilling to mount brackets.
| MGB GT Tailgate | $68.00 |
Reg. Retail $79.99 |
|
|
Gas charged bonnet lift kit and instructions for Triumph Spitfire 1962-1980 and MK3 GT6
Everyone knows how heavy and awkward the Spitfire and GT6 Bonnets are, so treat yourself and your bonnet to this marvelous new Bonnet Lift Kit!
Two powerful gas springs will now make lifting your bonnet a thing of ease! The initial lifting force is substantially reduced, and after opening only a portion, the springs take over completely and raise your bonnet Fully Open. Because there is even support there is no risk of the bonnet being damaged.
Lowering the bonnet is so much better, too! The weight does not build and build like before, but instead you "pull" the bonnet down and then lower it for only the last portion while the springs help counterbalance the weight!
This cleverly engineered design requires NO DRILLING. Custom fabricated brackets and ball studs fasten to existing geometry. Gas Springs have even been custom made for just this application--they are not "off the shelf."
| Triumph Spitfire MK1-MK3 Bonnet 62-70 | Only $75.00 | Reg. Retail $89.99 |
| Triumph Spitfire MKIV/1500 Bonnet 71-80 and MK3 GT6 | Only $93.50 | Reg. Retail $109.99 |
|
|
Single gas charged boot lift kit and instructions for Triumph Spitfire
Fits All Years Triumph Spitfire. Transform your Boot Lid operation with this Kit! (Fits Square Tail Spitfires--but can be adapted to fit early tubular frame Spits, will need longer 10mm ball stud)
Make that heavy lid almost weightless, even to the point of opening it with One Hand!
Super easy to install, takes just 5 minutes! No drilling required!
| Triumph Spitfire Boot | Only $36.00 |
|
|
|
|
Single gas charged boot lift kit and instructions for Triumph TR4/4A/250
Make that heavy lid much lighter to lift or lower with this lift assist Kit!
Our Ball Studs are specially manufactured to match the 1/4-28 thread on the lower bracket, and our Gas Springs are manufactured to our specifications of dimensions and strength.
Super easy to install, takes just 10-15 minutes. Requires minor drilling to slightly enlarge existing mounting hole in tube of boot lid.
Note: Shown on Triumph Spitfire Lid, but installs the same.
| Triumph TR4/4A/250 Boot | Only $49.99 | Reg. Retail $58.99 |
|
|
Dual gas charged bonnet lift kit and instructions for Triumph TR6/TR250
Make lifting your bonnet a thing of ease! Additionally, eliminate the uneven support from the factory prop, and the twisting to your bonnet it can cause over the years.
Requires only two discreet holes be drilled. This is a modification you will appreciate Every time you open your bonnet!
| Triumph TR250/6 Bonnet | Only $93.50 | Reg. Retail $109.99 |
|
|
Dual gas charged boot lift kit and instructions for Triumph TR6/TR250
Everyone knows how ridiculously heavy the TR6 Boot Lid is. Install this kit, however, and you can lift it with just a finger!
Not only is this nice for ourselves, it's also nice for our Triumphs, to eliminate racking caused by years of one-sided support using the factory prop.
This is a modification you will appreciate Every time you open your boot lid.
| Triumph TR250/6 Boot | Only $56.00 | Reg. Retail $65.99 |
|
 |
MGBGT spare tire/deck lid lift kit
Every MGBGT owner knows the hassle of the spare tire panel (tailboard). You need three hands!??
The Lid is heavy and cumbersome, and you end up propping it up with your head to free up your hands--especially to access the actual spare tire--
and that is just sketchy and uncomfortable!
Install this Kit and never have that hassle again. The gas springs will help you lift the Lid and then hold it up until you are finished.
Kit requires drilling; Installation Instructions. Fits all early cars up until approximately 1974 when the larger tailboard with the piano hinge was adopted. This kit can also fit these later cars, but with modification in bracket placement.
| MGBGT Boot Deck Lid | Only $63.00 |
|
|
